Viessmann photovoltaic modules can be installed quickly and safely on sloped roofs (between 10 and 60 degrees roof pitch) as well as on flat roofs. The only important factor is that the roof in question can safely support the weight of the modules, even in adverse conditions.
Photovoltaics – power from the sun
Topics at a glance
With a photovoltaic system, sunlight can be converted into electrical energy. This is based on the "photo effect", which was discovered back in the 19th century, but could only be physically explained and put to use in the course of the 20th century. The first area of application was space travel. Today, the technology can be found on many a roof and supplies residents with electricity from free solar energy. Photovoltaics are also suitable for reducing the energy costs of commercial and local authority users, while at the same time contributing to climate protection.
How do photovoltaics work?
The way photovoltaics work is based on solar cells. These cells convert radiant energy into electrical energy. The cells can be connected together to form modules and then installed on roofs, façades and in open spaces. Electricity generation can be broadly divided into two steps:
- Harvesting energy: When light falls on the photovoltaic modules (PV modules), electrons are released inside the solar cells. Positive and negative charge carriers collect at the respective electrical contacts, resulting in a DC current flow between the front and back of the cell. This photoelectric effect is created without mechanical or chemical reactions, and so is maintenance-free and not subject to wear.
- Power conversion: The DC power generated by the solar generator is then converted by the inverter (commonly also known as a solar inverter or mains feed-in device) into AC power suitable for the grid (230 or 400 volt AC current at 50 Hz). Proven safety standards and fully developed processors, as well as cutting edge power electronics, ensure effective conversion of the solar power. The alternating current generated can then be used in the home or fed into the public grid.
Structure of a silicon solar cell
Note: There is a difference between solar and photovoltaic systems. A solar system is the generic term for systems that use solar energy, including photovoltaic systems (PV systems), which convert sunlight into electricity, and solar thermal systems, which use solar energy to generate heat.
The different module types
The efficiency of photovoltaics depends on the manufacturing process of the solar cells. With Viessmann photovoltaic modules, a distinction can be made between monocrystalline and polycrystalline cells:
- Monocrystalline cells: Powerful cells from pure single crystals (Efficiency:14 to over 19 percent)
- Polycrystalline cells: Manufactured from cast silicon blocks with crystals of different orientation (Efficiency: 12 to over 17 percent)
Both monocrystalline and polycrystalline Viessmann solar cells are suitable for use in residential, municipal and commercial buildings. A Viessmann specialist partner will help you choose the most suitable option for you.
Take advantage of the benefits of photovoltaic systems
With energy costs constantly rising, a photovoltaic system helps users to save money and reduces their reliance on power supply utilities. The power they generate can be used for their own needs or exported to the public grid. Thanks to statutory remuneration and savings resulting from self-consumption, the investment pays for itself in just a few years. A photovoltaic system also increases the value of the property.
By installing PV modules, the operator takes concrete steps to reduce CO₂ emissions and actively contributes to climate protection.
Independence
Reducing dependence on energy suppliers and fluctuations in energy prices.
Feed-in remuneration
Possibility of feeding surplus electricity into the grid and receiving remuneration.
Increase in the value of the property
Increasing the value of the property by installing a PV system.
Renewable energy source
Use of solar energy, which is unlimited and renewable.
Low maintenance
Low maintenance and long service life of the modules.
Energy self-sufficiency
Can be combined with storage systems to increase self-sufficiency.
Viessmann photovoltaic technology quality guarantee
Our high quality photovoltaic modules ensure economic efficiency and a long service life. Comprehensive services – from engineering and sizing through to delivery and maintenance – round off the photovoltaic range available from Viessmann's professional partners.
Viessmann photovoltaic technology offers you perfectly coordinated components consisting of PV modules, inverters and installation systems, as well as power storage systems and heat pumps to increase self-consumption.
Feed-in remuneration and self-consumption
Owners of photovoltaic systems currently have two options for utilizing the electricity generated. The electricity can either be fully fed into the grid or partially or fully used by the owner. In both cases, a photovoltaic system pays off.
Self-consumption of PV systems is becoming more attractive
In recent years, feeding all of the solar power into the grid was financially more attractive. However, falling feed-in tariffs and rising electricity costs are making self-consumption increasingly attractive. As electricity costs per kilowatt hour are often higher than the feed-in tariff, the photovoltaic electricity generated is increasingly being used by consumers themselves or stored in batteries, and only surpluses are fed into the grid. This is regulated by the Renewable Energy Sources Act (EEG), which stipulates that energy suppliers must purchase the electricity they do not use themselves. A well-planned system concept with coordinated components maximizes self-consumption.
[1] Photovoltaic system [2] Photovoltaic inverter [3] Photovoltaic meter [4] Consumer [5] Heat pump meter [6] Heat pump [7] Consumption and export/generation meter [8] Public grid
Complete solution: combining a photovoltaic system with a heat pump
The most efficient way to generate heat from power is by using a heat pump. With a heat pump, one kilowatt-hour of electricity can provide up to four kilowatt-hours of heat by using free environmental energy. If a heat pump is used to cover the energy demand for heating rooms and domestic hot water, low cost solar electricity enables an inexpensive heat supply. Those intending to combine a photovoltaic system with a heat pump should select environmental heating that specifically optimises self-consumption and can be adapted to match the generating patterns of the PV system. For this purpose, Viessmann has developed a carefully matched system comprising photovoltaics and heat pump.
[1] Photovoltaic modules [2] Solar collectors [3] Split air/water heat pump [4] Outdoor unit of the heat pump [5] Domestic ventilation unit [6] Electricity storage system
Proper planning is essential for economic operation
In order for the technology to work economically and reliably, a few points need to be considered. In addition to a high product and execution quality, it also depends on the right planning. Anyone considering purchasing a photovoltaic system should firstly check with one of our partners whether the prerequisites have been met.
Orientation, inclination and shading of the roof surfaces
South facing roofs without shade are ideal for photovoltaics. With an inclination of 30 to 40 degrees, the sun's rays strike the Vitovolt 300 solar modules at just the right angle, so that the cells generate plenty of electricity. If the inclination is favourable but the orientation is shifted to the east or west, the yield will be 20 percent lower, on average. To compensate for the losses, you would need to purchase a larger photovoltaic system. The Viessmann surface matrix shows what output is possible on your roof. Interested parties can enter the width and height of the roof surface and quickly see how many modules can be installed.
The matrix shows an illustration of the suitable package for the available roof area. The intersection of roof height (Dachhöhe) and roof width (Dachbreite) gives the appropriate package (shown).
Check the load bearing capacity of the roof
Solar modules add a lot of weight to a roof. A structural engineer will quickly determine whether the roof can support the equipment. If renovation work needs to be carried out on the roof structure, homeowners can apply for financing with a loan from the Kreditanstalt für Wiederaufbau (KfW) [or local equivalent].
Standard values for the design in residential buildings
The Vitovolt 300 packages from Viessmann make selecting the right photovoltaic system particularly straightforward, based on just a few questions. The system that homeowners need to purchase depends on the number of people living in the household and the intended use of the technology. For example, more solar modules are required if the photovoltaics are also to supply a heat pump with electricity. When combined with a fuel cell, on the other hand, fewer modules are needed. This is because, in addition to heat, a fuel cell produces electricity for self-consumption. The following table shows approximate standard values.
Quick FAQ about photovoltaics
Which roof shape is suitable for operating a PV system and is regular cleaning necessary? We answer these and other questions below.
In practice, around 30 percent of a house's total energy needs can be met with photovoltaics. You can achieve higher self-consumption with the aid of a power storage unit, such as the Vitocharge. A share of 70 to 80 percent is realistic. Using an electric car or an e-bike also makes sense.
If you want to commission a photovoltaic system and receive the feed-in tariff, there are a few things that you need to consider.
1. You must submit an application for grid connection (grid connection request) to your local power supply utility. You can find out who your local power supply utility is by checking your last energy bill. If there is no name, but only a 13-digit code, then enter it on this website.
2. The grid compatibility test is carried out by the power supply utility. As part of the check, the utility will verify that the local electricity grid is designed for the planned PV system or not. You can usually complete the first two steps with your solar engineer.
3. Two weeks before commissioning your photovoltaic system, you must register it with the Federal Network Agency [Germany]. More specifically, the system must be registered in the Market Master Data Register of the Federal Network Agency [Germany]. Registration is extremely important and forms the basis for your feed-in tariff. In other words: no registration = no remuneration!
4. After commissioning, you will receive a "system passport". This includes all technical details for the system, all documents for installation and a commissioning report. The system passport is comparable with a car's logbook and is indispensable, particularly for legal protection.
If you commission a photovoltaic system and export some of the electricity generated into the local grid, you have to pay taxes. The taxes you are required to pay will depend, among other things, on the size of your system. In principle, the following types of tax may be levied on a PV system:
- Trade tax
- Value added tax (VAT)
- Land transfer tax
- Income tax
Most systems of average size achieve such low output that their operators do not need to pay trade tax. The VAT obligation, on the other hand, only applies when more than half of the self-generated electricity is fed into the grid. System operators only have to pay land transfer tax if the following applies:
- A property is purchased with a system already installed.
- In the case, this is an "in-roof system" (solar system installed directly into the roof).
Only the profit (feed-in tariff minus running costs incl. maintenance and repair costs, insurance, etc.) needs to entered on the income tax return. To be clear on what exactly needs to be entered, it is best to consult your tax advisor.
Modern solar modules are almost self-cleaning due to their inclination and very smooth surface. In addition, wind and rain remove most of the dust. In the case of snow or coarser soiling caused by fallen branches, for example, cleaning is nevertheless advisable. It is best to hire a specialist company for this work, as the working height poses a certain risk. There is also a risk of the warranty becoming void due to incorrect cleaning.
If you feed electricity into the public grid, you will receive a payment from your power supply utility for 20 years. Once this period has elapsed, the feed-in tariff will no longer apply. You can still "offer" the self-generated electricity on the market, however. However, depending on the quantity, that search could prove difficult. Alternatively, you can use all of the electricity on site. Another option is to modernise the system. You replace the old modules with new, more powerful ones. You can usually continue using the existing mounting frame.
Photovoltaic charging station at the Allendorf site
Viessmann customers, suppliers and guests now have the opportunity to recharge the batteries of their electric vehicles ready for the rest of their journey. In front of the information centre at the Allendorf plant; six "pumps" are available for this purpose. 100 percent of the electricity comes from the Viessmann photovoltaic modules on the roof of the charging station.
A BMW i3 painted in bright Vitorange is also charged there. It complements the Allendorf vehicle fleet and is used for journeys in and around the site.
